Vaisala Indigo300 - Figure 17 Connecting Indigo300 Transmitter to Insight PC Software

The service port connection is only intended for temporary use
during configuration, and must not be used for permanent installations. The IP
rating and EMC properties of the transmitter can be aected when the service
port is open.
CAUTION!
Upon connecting, the transmitter receives date and time settings from Insight.

1 3
2
OPEN >>
Figure 17 Connecting Indigo300 transmitter to Insight PC software
1
M8 connector of the service cable
2 M12 connector of the service cable
3 USB adapter
1. Open the protective cover of the transmitter service port using the 4-mm Allen key.
2. Connect the M8 connector of the service cable to the service port.
3. Connect the USB adapter to the M12 connector of the M12 - M8 service cable (262195).
4. Connect the USB adapter to a free USB port on the PC.
5. Open the Insight software on your PC.
6. Wait for the Insight software to detect the transmitter.
Chapter 4 – Using transmitter with Insight PC software
31