Vaisala Indigo300 - Selecting Displayed Units

5.4 Selecting displayed units
You can use the Indigo80 handheld indicator to change the units of the measurement
parameters shown on the transmitter display.
The unit selection has an eect on entering configuration values (for example,
whether you must enter analog output scale settings as ppm or % values).
1. Connect the transmitter to the indicator.
2. Open the main menu by pressing .
3. Select Devices. If you have more than one device connected to the indicator, make a
further selection between the devices.
In this case, select Indigo300.
4. Select Settings.
5. Select Displayed units.
6. Select the unit you want to use for each parameter.
7. Exit the menu by pressing
or return to the main menu by pressing .
More information
‣
Connecting to Indigo80 handheld indicator (page 36)
Chapter 5 – Using transmitter with Indigo80 handheld indicator
39