Vaisala RVP900

Appendix C _____________________________________________ Installation and Test Procedures
VAISALA______________________________________________________________________ 363
C.1.1 Test Checklist
Test Passed

C.2 Installation Check

C.3 Power Up Check

C.4 Setup Terminal

C.5 Setup "V" Command (Internal Status)

C.6 Setup "Mc" Command (Board Configuration)

C.7 Setup "Mp" Command (Processing Options)

C.8 Setup "Mf" Command (Clutter Filters)

C.9 Setup "Mt" Command (General Trigger Setup)

C.10 Initial Setup of Information for Each Pulse Width

C.11 Setup "Mb" Command (Burst Pulse and AFC)

C.12 Setup "M+" Command (Debug Options)

C.13 Setup "Mz" Command (Transmitter Phase Control)

C.14 Ascope Test

C.15 Burst Pulse Alignment

C.16 Bandwidth Filter Adjustment

C.17 Digital AFC (DAFC) Alignment (Optional)

C.18 MFC Functional Test and Tuning (Optional)

C.19 AFC Functional Test (Optional)

C.20 Input IF Signal Level Check

C.21 Calibration and Dynamic Range Check

C.22 Receiver Bandwidth Check

C.23 Receiver Phase Noise Check

C.24 Hardcopy and Backup of Final Setups

C.25 RVP901 TxDAC Stand-alone Bench Test
For Customer_________________________________ Date__________
For Vaisala___________________________________ Date__________