Chapter 7 __________________________________________________ Host Computer Commands
VAISALA______________________________________________________________________ 331
0916-176
7.29 Set Individual Thresholds (THRESH)
The SOPRM command in Section 7.3 Setup Operating Parameters
(SOPRM) on page 259 allows you to configure four threshold numbers
used by all data types, and to select the threshold control flags for five of
the data types. See that section for detailed documentation on how the
thresholds work. Use the THRESH command if you wish to apply different
threshold numbers to different data types. Using this command you can
individually set the thresholds and mask used for each data type, or for
groups of data types. Note that the GPARM command will read out the
threshold numbers set for velocity. To read back the numbers for each data
type use the RBACK command (Section 7.19 Read Back Internal Tables
and Parameters (RBACK) on page 319).
0916-177
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| | 0 0 0 1 0 0 1 1 1 1 1 1 | Command
|_______________|_______________________________________________|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| 64 Permanent User Bits to SET | Inputs 1–4
|_______________________________________________________________|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| 64 Permanent User Bits to CLEAR | Inputs 5–8
|_______________________________________________________________|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| 64 User Bits to Apply ONCE | Inputs 9–12
|_______________________________________________________________|
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
| | | | | | | | | | | | | | | | |
| | 0 0 0 1 0 1 0 1 1 1 1 1 | Command
|_______________|_______________________________________________|
To Next Page
Loading...