MC095 - MCP-8 Control Unit Section 5 - Operation
63
Set the Pattern Menu Information - Continued
Scanner Lockout - Enter a product length to act as a scanner lockout when holes, writing, or other items produce a
false trigger by the scanner.
Batch Counter:
Batch counting is often used on a machine with manual packers. This option allows a kicker or marking valve to
identify a group of products needing to be packed into a box.
Batch Counter-On/Off- Turn the batch counter on and off with the “switch” using the Plus/Minus Buttons.
Batch Counter-Skip - The total number of products for which the pattern will be skipped (no adhesive will
be applied).
Batch Counter-Glue - The total number of products the adhesive pattern will be applied to, one after the
other without skipping any products.
The Batch Counter must be enabled under the Setup Menu.
Scanner - Select a scanner from the scroll list, using the plus and minus keys to highlight, press the Left or Right
arrow to highlight “Apply,” and then press OK.
Cell to Gun Distance - Measurement - The distance between the valve (gun; shown on the left of the screen) to the
scanner (cell) number, shown in the upper right corner. This value must be entered accurately to achieve proper
pattern placement.
To Next Page
Loading...
Need help?
General