Section 5 - Operation MC095 - MCP-8 Control Unit
64
Set the Pattern Menu Information - Continued
Jog Mode - The Jog Mode Parameter is only available when Jog Mode is enabled.
When jog mode is enabled, and the machine speed is below ‘Jogg Speed,’ the pattern will be divided into a series of
dots and gaps. When the machine speed increases beyond Jogg Speed, the pattern will return to a unified bead. Jog
mode is used to prevent applying excessive adhesive at slow machine speeds, as well as to help clear a dried nozzle.
Jog Mode - On/Off - Turn the jog mode on and off with the “switch” by clicking on the “OK” button.
Dot Size - The size of the adhesive dots, from 1 (smallest) to 9 (largest).
Dot Gap - This is the distance between the glue dots while the machine is running below the jogging speed threshold.
Increase the distance to decrease the glue volume.
Jogg Speed - Controls the speed at which the pattern will transition from dots to a unified line, in m/min.
To Next Page
Loading...
Need help?
General