Engineer programming via the keypad
Installation & Configuration Manual
is closed. (1 – 45 seconds)
Activates the external bell momentarily to indicate a full set
condition. (0 – 10 seconds)
Activates the strobe on the external bell momentarily to
indicate a full set condition. (0 – 10 seconds)
Number of seconds to display fail to set message on keypads
(0 until valid PIN is entered). (0 – 999 seconds)
The maximum delay between activation’s of zones with the
double attribute, which will cause an alarm. (1 – 99 seconds)
The number of days a zone remains under soak test before it
automatically returns to normal operation. (1 – 99 days)
The average period between seismic sensor automatic tests
(12 – 240 hours)
Note: To enable automatic testing, the Automatic Sensor Test
attribute must be enabled for a seismic zone.
Maximum time (in seconds) that a seismic sensor takes to
trigger an alarm in response to the 'Seismic Test' output.
(3 - 120 seconds)
Duration after alarm that access will be denied.
Duration that the strobe output will be active when an alarm is
activated. (1 – 15 minutes; 0 = indefinitely)
The time after a mains fault has been detected before an alert
is activated by the system. (0 – 60 minutes)
The timer for the Engineer access starts as soon as the user
enables the Engineer Access. (0 – 999 minutes. ‘0’ indicates
no time limitation for system access)
Duration of inactivity after which the engineer will be
automatically locked out
The number of seconds that an RKD will wait for key entry
before it leaves the current menu. (10 – 300 seconds)
The duration a keypad will wait in idle before switching
language to default ( 0 - 9999 seconds; 0 = never).
Number of seconds to wait before reporting fire alarm for
zones with ‘Fire pre-alarm’ attribute set. (1 – 999 seconds)
See Editing a Zone [âž™ 237].
Extra time to wait before reporting file alarm for zones with
‘Fire pre-alarm’ and ‘Fire Recognition’ attributes set. (1 – 999
seconds). See Editing a Zone [âž™ 237].
Period for which pin is valid in days ( 1 - 330 )
Number of changes within a valid period ( 1 - 50 )
Time before PIN expiry after which a warning will be
displayed
To Next Page
Loading...
Need help?
General
