Vanderbilt SPC6350 - Default Chapter; Table of Contents

3
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
Table of contents
1 Meaning of symbols ......................................................................................... 11
2 Security ............................................................................................................. 12
2.1 Target group ....................................................................................................... 12
2.2 General safety instructions ................................................................................. 12
2.2.1 General information ............................................................................ 12
2.2.2 Transport ............................................................................................. 12
2.2.3 Setup ................................................................................................... 13
2.2.4 Operation ............................................................................................ 13
2.2.5 Service and maintenance ................................................................... 13
2.3 Meaning of written warning notices .................................................................... 14
2.4 Meaning of hazard symbols ............................................................................... 14
3 Directives and standards ................................................................................. 15
3.1 EU directives ...................................................................................................... 15
3.1.1 Overview of Conformity to EN50131 Standard ................................... 15
3.1.2 Compliance with EN50131 Approvals ................................................ 19
3.1.3 Compliance with EN 50136-1:2012 and EN 50136-2:2014 ................ 21
3.1.4 Compliance with INCERT Approvals .................................................. 21
3.1.5 PD 6662:2010 Conformance Guidelines ............................................ 23
3.1.5.1 Product scope ..................................................................................... 23
3.1.5.2 Standards overview ............................................................................ 23
3.1.5.3 Methods for the completion of setting and unsetting .......................... 23
3.1.5.4 Configuration requirements for PD 6662:2010 conformance ............. 26
3.1.5.5 Additional commissioning requirements for PD 6662:2010
conformance ....................................................................................... 27
3.1.5.6 Additional information ......................................................................... 28
3.1.6 Compliance with VDS approvals ........................................................ 28
3.1.7 Compliance with NF and A2P approvals ............................................ 29
4 Technical Data .................................................................................................. 31
4.1 SPC4000 ............................................................................................................ 31
4.2 SPC5000 ............................................................................................................ 32
4.3 SPC6000 ............................................................................................................ 35
4.4 SPCP355.300 ..................................................................................................... 38
5 Introduction....................................................................................................... 39
6 Mounting system equipment........................................................................... 40
6.1 Mounting a G2 housing ...................................................................................... 40
6.2 Mounting a G3 housing ...................................................................................... 41
6.2.1 Mounting a Back Tamper Kit .............................................................. 43
6.2.2 Battery installation for EN50131 compliance ...................................... 47
6.3 Mounting a G5 housing ...................................................................................... 48
6.3.1 Tamper protection ............................................................................... 50
6.3.2 Mounting the housing with tamper protection ..................................... 50
6.3.2.1 Tamper operation ................................................................................ 51