Installation & Configuration Manual
7.1.6 System Recovery
Mains and Battery Failure
In the event of both mains and battery power failure, the PSU kickstart switch (item
25 in SPCP355.300 Smart PSU [➙ 55]) enables the system to be restarted if only
battery power is reinstated. To kickstart the system, do the following:
Mains power has failed
Battery power has failed
New batteries are available
1. Attach the battery leads.
2. Press and hold the PSU Kickstart button.
All LEDs flash.
3. Hold the PSU Kickstart button until the LEDs stop flashing.
4. Release the PSU Kickstart button.
PTC Fuse Reset
In the event of one of the PTC fuses resetting, you must manually disconnect then
reconnect the mains and battery connections.
To Next Page
Loading...
Need help?
General
