Installation & Configuration Manual
The LED indications for information, area status, alarm and fault is deactivated in
idle state of the keypad. A valid user PIN has to be entered. It is configurable if
the power indication can be seen in idle state.
12.2.3 Viewing mode description
There are 2 viewing modes (automatic):
Multi area view: User has access to several areas. Displaying the areas is done
via area groups. If no area group is configured, only the general group “All my
areas” is displayed.
Single area view: The user has only rights for 1 area. In the single area view,
only one area is displayed in large fonts and can be controlled directly.
The rights of a user can be restricted by the user settings or the settings of the
keypad the user is logging in to. Only if the user and the keypad that is being
used for logging in have the right for an area, the area is displayed. If the user has
the right for several areas but the keypad has only the right for one area, the user
will also see the single area view.
12.2.4 Function keys in idle state
Emergency Keys
Depending on configuration, emergency keys are displayed. A simultaneous
pressing of the keys activates an emergency call.
To Next Page
Loading...
Need help?
General
