Vanderbilt SPC6350 User Manual

Engineer programming via the browser
17
Panel status
169
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
Name
Description
Communication
The physical status (OK, Fault) and the programmed status (OK,
Isolated, Inhibited) of the X-BUS cable connection to the
expander.
Cabinet Tamper
The physical and programmed status of the expander cabinet
tamper.
Fuse Fault
The physical and programmed status of the expander fuse.
Controller Mains Fault
The physical and programmed status of the mains supply to the
controller.
Battery Fault
The physical and programmed status of the battery.
PSU Fault
The physical and programmed status of the PSU.
OP Tamper
The physical and programmed status of the tamper outputs on the
PSU.
Low Voltage
Indication of battery low voltage status.
Performable actions
Name
Description
Restore Alerts
Click the button to restore all alerts on the panel.
Inhibit
Click this button to inhibit a fault condition. The inhibit operation
will disable that fault or zone for one arming period only.
Inhibit operation is not available in Security Grade EN 50131
Grade 3.
Isolate
Click this button to isolate that zone. Isolating a zone will de-
activate that zone until such time as the zone is explicitly de-
isolated again. It is recommended that you exercise caution when
isolating zones as those zones will not be active every time the
system is SET.
!

Vanderbilt SPC6350 Specifications

General

Brand	Vanderbilt
Model	SPC6350
Category	Power Supply
Language	English