Disassembly - Carburetor - Vanguard Model 610000
The Vanguard Model 610000OHV V-Twin utilizes a fixed jet,
two-barrel, side draft, flo-jet carburetor. Except for idle speed,
the carburetor is non adjustable. The carburetor incorporates
a fuel shut-off (anti-afterfire) solenoid that controls the flow to
the fuel metering system. The solenoid is controlled by the
ignition switch.
1. Remove the 4 float bowl fasteners (A, Figure 146)and
remove the float bowl (B) and gasket. Discard gasket.
2. Using a thin profile wrench, remove the anti-afterfire
solenoid (C) from the float bowl. Discard sealing washer.
3. Remove the main jets (D) from the float bowl.
4. Remove the float hinge pin, float (E), and needle from the
carburetor body.
5. Remove the limiter caps and mixture adjustment screw
(F) from both sides of the carburetor.
6. Remove the choke plate fasteners and choke plate (G).
7. Remove the circlip and washer that secure the choke
shaft to the carburetor. Remove the choke shaft (H) and
bushings from the carburetor.
8. Mark the throttle plates (I) before removal so they can be
re-installed in the original position.
9. Remove the throttle plate fasteners and throttle plates.
10. Remove the circlip and washer that secure the throttle
shaft (J) to the carburetor. Remove the throttle shaft,
bushings, and seal from the carburetor. Discard seal.
115
To Next Page
Loading...
Need help?
General
