7. Install the inner baffle (G) with raised edges(J)facing
OUT.
NOTE: DO NOT forcibly install components. One corner of
the breather components have a sharper radius than the
others to ensure correct alignment.
8. Install the reed valve assembly (E) into the valve cover
(H) with the reed valve facing out.
9. Install O-ring (F) into valve cover groove. Inspect for
dryness, cracking, or cuts.
10. Install the outer baffle (D) into the breather cover with the
three bosses facing out.
11. Install the breather cover (C) and baffle onto the valve
cover.
12. Start 2 fasteners (B) and alternately tighten to 43 lb-in
(4.9 Nm).
129
To Next Page
Loading...
