1. Spray NACL Precision Optics Cleaner solution onto a clean, dry microfiber cloth.
2. Gently wipe the VLS-128’s ring lens along the curve of the sensor, not top-to-bottom.
I.1.6 Method Four
Use a diluted mixture (50/50) of Simple Green and distilled water to remove particulates on the lens with a rinsing action.
After heavy particulates are removed, additional Simple Green solution and a soft microfiber cloth can be used gently to
clean the lens. This should then be followed up with a 99% IPA (Isopropyl Alcohol) wipe using a microfiber cloth to remove
any residual Simple Green. Never use an ammonia-based cleaner.
Appendix I • Sensor Care 127
To Next Page
Loading...
