Velodyne VLS-128 User Manual

4.2.2 Access Sensor’s Web Interface
Now the computer is ready to connect to the sensor.
1. Plug the Ethernet cable into the computer and then plug its other end into the Ethernet port on the sensor’s Inter-
face Box. Figure 4-2 below shows the Interface Box, its external ports, internal sensor terminal, and fuse.
Figure 4-2 Interface Box (power and data connections)
2. Connect power to the sensor’s Interface Box.
When power is applied, two green LEDs in the Interface Box light up. The sensor begins scanning its environment
and transmitting data approximately 30 seconds after power up.
3. On the computer, point a browser to http://192.168.1.201.
4. The sensor’s Web Interface should appear ( Figure 4-3 below ).
The Web Interface provides access to many of the sensor’s control settings. See Web Interface on page 67 for
details.
Figure 4-3 Sample Web Interface Main Configuration Screen
Chapter 4 • Unboxing & Verification 25
DRAFT

Velodyne VLS-128 Specifications

General

Brand	Velodyne
Model	VLS-128
Category	Accessories
Language	English