Vertical SBX IP 320 - Do-Not-Disturb (DND)

Internet Protocol (H.450) 114
SBX IP 320 Features & Operation Guide
• For CO Transit-Out, any code will be available using NET Routing Table (PGM 324). If
there is a conflict between NET Routing Table and System Numbering Plan, the System
Numbering Plan will have the highest priority.
• If the CO Transit-Out code is programmed in the Network Numbering Plan Table, then
the type value of this entry must be set to PSTN (PGM 324).
• If the Networked System isn't connected to the Master System directly, the CO
Transit-Out code can be transmitted through the other networked Systems transparently
by setting the PGM 324.
• At the Master System, the PSTN CO lines must be set (PGM 322).
Admin Programming
• Networking CO Line Type (PGM 322 - FLEX 2)
• Network Routing Table - Numbering Plan (PGM 324)
Do-Not-Disturb (DND)
Net Calls to a Station can be rejected using the DND mode; the Calling Station will hear a busy
tone.
Operation
To activate DND mode:
1. Press the [DND] button at the Station.
2. When a call is received at the Station, the Caller will hear a busy tone; the Station in DND
mode will not receive any notification of the call.
Condition
• When a Station is in DND mode, the [NET DSS] of the DND Station will flash if the BLF
(Busy Lamp Field) manager is activated.
Admin Programming
• DND Attribute (PGM 111)