Outgoing Call Access 142
SBX IP 320 Features & Operation Guide
Hot Line & Warm Line
A station user can instantly make an outgoing call by lifting the handset or pressing the [ICM],
if the user has previously stored the destination.
The destination can be a CO Line or CO Line Group; the function can be setup on a Flexible
Button, or at another Station.
Hot Line can be activated immediately when the Station is in the off-hook state; Warm Line can
be activated after the Warm Line Timer has expired. If the user dials another number prior to the
Warm Line Timer expiration, the call will activate as a normal call, not as a Warm Line call.
Operation
To activate a Hot Line:
Lift the handset at a station where Hot Line is assigned. The assigned Hot Line feature is
immediately activated.
To activate Warm Line:
Lift the handset at a station where Warm Line is assigned. The assigned Warm Line
feature is activated if no dialing has been done while the Warm Line Timer is running.
Conditions
• A station can be assigned Hot Line or Warm Line with Admin Programming (PGM 113 -
FLEX 7).
• If there is no Flexible Button at the station, the number is operated as a Speed Dial
Number.
• The set value of the Warm Line Timer should be less than that of the Dial Tone Timer.
• A Flexible Button may be assigned as an Idle Line Selection button.
• When lifting the handset or pressing the [SPEAKER] button, the system will be activated
as a predefined button if pressed.
• It is possible to activate Hot Line/Warm Line at an SLT station.
Admin Programming
• Warm Line Timer (PGM 182 - FLEX 8)
• Warm Line (PGM 113 - FLEX 7)
• Idle Line Selection (PGM 122)
To Next Page
Loading...
