Outgoing Call Access 141
SBX IP 320 Features & Operation Guide
CO Step Call - Analog Only
When an analog Station receives a busy tone after accessing a CO Line, you can dial a CO Line
number which has the same first digits as the called busy CO Line without dialing the full
number.
Operation
To use CO Step Call when receiving a busy tone, use the following procedure:
1. Press the [SPEED] button and dial the last digit of the previously called number.
2. The previous call is terminated and a new call is established.
Emergency Call Service
You can dial the Emergency Service Code regardless of lower station COS.
Conditions
• An emergency call can be dialed by pressing an available CO Line at the station that is
assigned to COS 7.
• If the dialed number for the Emergency Service Code is the same as a station number on
the system, or LCR number, the call is operated as an Emergency Call. The preference of
the programmed dial number that is sent to external CO Line is:
Emergency Call Code>LCR Table>Station Number
Admin Programming
• Emergency Service Call (PGM 226)
To Next Page
Loading...
