Voice Service 223
SBX IP 320 Features & Operation Guide
Two-way Recording
Two-way Recording via SMDI
This feature allows a station to record a conversation into the mailbox by pressing a
{RECORD} button while the station is talking with a CO party.
Operation
To set a {RECORD} flexible button programmed for the Two-way record feature:
1. Press the [TRANS/PGM] button.
2. Press the FLEX button (to be assigned).
3. Press the [TRANS/PGM] button.
4. Dial 54.
5. Press the [HOLD/SAVE] button.
While a station user is in a conversation with a CO line caller, the user can press the {RECORD}
button and the conversation will be recorded in the user's mailbox. The user presses the
{RECORD} button again or hangs up to end the recording.
Protocol: When the User presses the {RECORD} button, the System sends a SMDI message to
Voice Mail PC through RS-232C cable. The format is the same as follows.
=>"crlfMD0010mmmmH0xxxxxxxxxbbcrlf^Y"
cr : carriage return,
lf : line feed,
mmmm : VM port number,
H : Action code for recording,
xxxxxxxxx : extension which try to record,
b : ascii space.
Conditions
• When the recording feature is enabled, the {RECORD} button will flash at 240 ipm. If it
is disabled, the {RECORD} button will not be lit.
• The recording feature is not available to SLT.
• The recording operation is canceled when station goes off-hook, presses the {RECORD}
button again, presses the [FLASH] button, or the CO party hangs up.
To Next Page
Loading...
