Call Handling 32
SBX IP 320 Features & Operation Guide
Camp-on
When you call a busy Station, the busy tone sounds. You can give a signal to the busy Station.
The busy Station (off-hook or on speakerphone) is notified of the call waiting by a camp-on tone
and the [HOLD/SAVE] button LED flashes.
An SLT User may notify a busy Station of an outside CO call or internal call waiting (camp-on
tone).
Operation
To activate Camp-on while receiving the Intercom busy tone, use the following procedure:
Dial * or the last digit of the busy station.
-or-
Press the busy DSS flexible button
-or-
Press the flexible button assigned as {Camp-On}.
To answer a Camp-on call while receiving the Intercom busy tone, use the following procedure:
1. Press the [HOLD/SAVE] button; the active CO line is placed on exclusive hold and the
call waiting is connected.
2. Press the [HOLD/SAVE] button, to alternately talk with both parties.
To activate Call Waiting on an SLT while receiving the Intercom busy tone, use the following
procedure:
1. Go Off-hook, then dial * or the last digit of the dialed Station number.
2. When answered, the call should be announced.
-or-
Replace the handset and go on-hook.
To answer the call waiting/camp-on, use the following procedure:
1. When the SLT station is busy, the camp-on tone is heard indicating a camp-on call.
2. Hook-flash and dial 560.
3. The SLT Station should be connected to the camp-on call.
4. Hook-flash and dial 56 again, to connect to the original Station call.
To Next Page
Loading...
