ISDN Service 132
SBX IP 320 Features & Operation Guide
To delete all CLI messages at Attendant:
1. Press the [TRANS/PGM] button.
2. Dial 055.
3. Dial the Station range.
4. Press [HOLD] button.
To program the SPEED BIN number with CLI message:
1. At the retrieve CLI message LCD, press the [SPEED] button. The LCD display message
changes as a usual station speed dial program, except that it displays the CLI message
using an indication.
2. Press a Station speed bin number.
-or-
Press the [HOLD/SAVE] button.
3. After entering the speed bin number, a CLI message using indication is displayed onto
speed dial digit position. It means that CLI can be entered pressing [CONF] button. If you
want to assign the CO for speed, it must be prior to pressing the [CONF] button.
4. Press the [HOLD/SAVE] button to store the speed dial number.
Conditions
• The CLI display works with about any type of CO service, if CO line is ISDN. But CLI
message wait only works with the DID/MSN CO service type of the ISDN line.
• The total number of CLI message wait is 500 (on a System basis).
• A Station without an LCD can not receive CLI message wait even though CLIP is set to
ON.
• CLI messages are saved against power failure.
• When the call is routed to a Ring Group, the CLI Message Wait pertains only to the first
member of the Ring Group.
ENTER SPEED BIN NO(001)
CLI MSG USED
CLI MSG USED
ENTER CO-BTN/DIGIT(001)
To Next Page
Loading...
