Rerouting 180
SBX IP 320 Features & Operation Guide
Admin Programming
• Hold Preference (PGM 160 - FLEX 8)
Automatic Hold
When a station is connected to a CO Call, the Station User can make another intercom call just
by pressing the DSS button. In this case, the previous CO Call is automatically held.
Operation
To use Automatic Hold while on a CO Line call:
1. Press a {CO} button.
2. When the new CO Line is connected, the previous CO Call is placed the Admin
Programmed preferred Hold state.
Admin Programming
• Automatic Hold (PGM 112 - FLEX 2)
• Hold Preference (PGM 160 - FLEX 8)
Park
A User can park an ICM or CO call in a virtual location. The User can then make a page
announcement for the desired User to pick-up the parked call. The paged user can retrieve the
call by dialing the designated location number.
Note: A Station must have a {CO} or {LOOP} button, to retrieve the call.
Operation
To park a call:
1. Press the [TRANS/PGM] button.
2. Dial the parking location 601-608.
3. Replace the handset or go on-hook.
4. Page the desired User to retrieve the call.
To Next Page
Loading...
