Conference 77
SBX IP 320 Features & Operation Guide
To Transfer CO Call to conference room:
1. Press the [TRANS/PGM] button at the Attendant Station.
2. Dial the activated Conference Room Number (571-579).
3. Dial the password for entering the conference room (optional).
To check Conference Room status from the Attendant Station:
1. At the Attendant Station, dial a conference room status code [TRANS/PGM] + dial 0 + 4
+ 7.
2. Enter conference room number (1-9) to monitor.
3. The Attendant LCD will show the number of members joining the conference room.
To delete room forcedly by Attendant:
1. Dial a conference room forced delete code, [TRANS/PGM] + 048.
2. Enter the Room number and press [HOLD/SAVE].
3. When erasing Conference room at ATD station, password is not needed.
Conditions
• The Maximum number of conference rooms is 9.
• A maximum of 15 members can enter each room.
• Assigning and entering a password is Optional.
• CONF ROOM status can be checked by ATD (how many members are joining the
conference room).
• For CO party, only ISDN line can enter a conference room.
• If system attendant has a conference room button, she can check the status of conference
room by checking the LED indication.
- ON - The conference room is activated, but there is no members in the room.
- OFF - The conference room is deactivated.
- Flash 60 IPM - The number of members are 1 to 3.
- Flash 120 IPM - The number of members are 4 to 6.
- Flash 240 IPM - The number of members are more than 7.
• In case of Analog Line which is set to a valid "Open Loop timer" (PGM 142 - FLEX 13),
a DISA and transferred CO call can be a member of conference.
• PGM 160 - FLEX 11 option is used as a Conference feature. Entering and Leaving tones
are controlled by PGM 160 - FLEX 11.
To Next Page
Loading...
