Vertiv Avocent User Manual

6.1.4 Digital Output
The digital outputs are remote controlled relay ports. These ports, labeled DO1/DO2 on the back of the appliance, can be
used to open or close an electric circuit that can drive sirens, lights and locks.
To configure Digital Output notifications:
1. From the sidebar, go to Monitoring. Under the Notification Rules heading, check the boxes for the events for
which you want to trigger a digital output relay.
2. Click Apply.
NOTE: Digital Output (DO) relays are for events on the back of the appliance only.
3. From the sidebar, go to Monitoring - Notification Destinations and enter the Digital Output name and location
for Digital Output 1 and Digital Output 2.
4. Click Apply.
NOTE: Once the digital output relay has been triggered, use the override to reset it.
6.2 Sessions
The appliance allows multiple users to log in and run sessions simultaneously. The sessions screen allows you to view all
active sessions and delete any unwanted sessions. Click Sessions to view all open sessions on the appliance.
To delete a session:
1. From the sidebar, click Sessions. The sessions screen appears and lists all appliance and target sessions to the
appliance.
2. Select the checkbox next to the session you want to delete, then click the Delete button. After a few seconds,
the sessions screen will redisplay the open sessions, minus the one you deleted.
6.3 Support
From the sidebar, click Support to configure diagnostic logging. You can create and save a log file that can be downloaded
and sent to technical support. The log file contains debug information necessary for appliance technical support.
To enable system monitoring:
1. Click Support.
2. Check the box to enable system monitoring.
3. Set the frequency in minutes and click Apply.
4. Check the box to enable SPaccess monitoring.
5. Use the drop-down menu to select the Log Detail Level.
6. Click Apply.
To download the log file:
1. Click Support.
2. Click Download Log.
3. Browse to the save location and click Save.
6.4 Security
From the sidebar, click Security to enable or disable the following network services:
• Telnet
• SSH
• TLS v1.1
• HTTPS
• FIPS140-2
Vertiv | Avocent® Universal Management Gateway Appliance Installer/User Guide | 69

Vertiv Avocent Specifications

General

Ports	4
Network Interfaces	2 x 10/100/1000Base-T Ethernet
Management	Web-based, CLI
Remote Access	IP
Authentication	Local, LDAP, RADIUS, TACACS+
Encryption	AES
Operating Temperature	32 to 104°F (0 to 40°C)