Vertiv Avocent User Manual

NOTE: You can change the password for the logged-in user by clicking the logged-in username in the upper right and
then clicking Account.
4.3 Tabs
The tabs are the major navigation areas of the web UI. Only certain actions can be performed in certain tabs.
4.3.1 Targets
The information shown in the Targets tab is primarily read-only and is intended to facilitate user access to target sessions or
target control. For more information, see Targets on page 85.
4.3.2 Sensors
The Sensors tab is only visible on a Avocent® Universal Management Gateway 4000 or 6000 appliance. From this tab, you
can view read-only information regarding temperature, humidity, dry contact, smoke, motion, leak and other supported
environmental data. For more information, see Sensors and Events on page 93.
4.3.3 Events
The Events tab contains the event and alert logs for the appliance. The data shown on this tab is read-only except for the
ability to clear event and alert entries. For more information, see Sensors and Events on page 93.
4.3.4 Administration
The Administration tab contains all the necessary configuration and control settings to administer and operate the
appliance and its targets. The only configuration parameters not accessible from this tab are relevant to the Trellis™ Real-
Time Infrastructure Optimization Platform's data collection and monitoring capability. That behavior is fully controlled
within the Trellis™ platform. See the following section for more information.
Vertiv | Avocent® Universal Management Gateway Appliance Installer/User Guide | 21

Vertiv Avocent Specifications

General

Ports	4
Network Interfaces	2 x 10/100/1000Base-T Ethernet
Management	Web-based, CLI
Remote Access	IP
Authentication	Local, LDAP, RADIUS, TACACS+
Encryption	AES
Operating Temperature	32 to 104°F (0 to 40°C)