7 TARGETS
When logging into the appliance, the Targets tab is the default view. The Targets tab view consists of a sidebar and the
Targets table.
NOTE: The actions in this section can be performed by first clicking Targets in the tab bar.
Figure 7.1 Targets Tab
ITEM DESCRIPTION
1 Sidebar
2 Targets Table
Table 7.1 Targets Tab Descriptions
From the sidebar, you can access an appliance and its associated targets. From the Targets table, you can view information
about the target and open a session to it. The Targets table can be sorted according to column headers and the various
column widths can be resized according to preference. Customizations revert to default when the user logs out. The targets
can be viewed in three formats:list view, group view or type view depending on the selection made:
• The list view is a flat list of targets grouped under a parent appliance node. Selecting the appliance list item
shows a target summary screen.
• The type view shows all targets grouped by their target types.
• The group view shows only the defined target groups and their contents. Targets not in a group will not be
visible. Targets in more than one group will appear with each group. The group view shows Target groups that
have been created within the Administration tab.
STATUS
VALUE
DESCRIPTION
In Use Session is active
Upgrading Session is upgrading
Power On
One or more sockets are in the process of being turned
Table 7.2 Status Descriptions
Vertiv | Avocent® Universal Management Gateway Appliance Installer/User Guide | 85
To Next Page
Loading...
Need help?
General
