7.5.4 Current, Voltage, Power Consumption, Energy Consumption
By selecting the Current, Voltage, Power Consumption or Energy Consumption tabs, you can reset each's maximum,
minimum and average values.
To reset values:
1. Select PDUs and/or outlets to reset.
2. Select the Current, Voltage, Power Consumption or Energy Consumption tab as desired.
3. Click Reset Values.
7.5.5 Settings
By selecting the Settings tab, you can view and change the settings of Outlets, PDU, Phases, Circuits and Environment.
To configure Outlets settings:
1. Select a PDU to manage.
2. Click on the Settings tab.
3. Click Outlets.
4. Select the outlets you want to configure and click Edit. You can change the Post On Delay and Post Off Delay as
well as the High Critical, High Warning, Current Low Warning and Low Critical thresholds.
5. Click Apply when finished.
To configure PDUsettings:
1. Select a PDU to manage.
2. Click on the Settings tab.
3. Click PDU.
4. Select the PDUs you want to configure and click Edit. You can configure Cold Start Delay as well as High
Critical, High Warning, Low Warning and Low Critical thresholds and Estimated Power Factor.
5. Click Apply when finished.
To configure Phases settings:
1. Select a PDU to manage.
2. Click on the Settings tab.
3. Click Phases.
4. Select the phases you want to configure and click Edit. You can configure High Critical, High Warning, Low
Warning and Low Critical thresholds.
5. Click Apply when finished.
To configure Circuits settings:
1. Select a PDU to manage.
2. Click on the Settings tab.
3. Click Circuits.
4. Select the circuits you want to configure and click Edit. You can configure High Critical, High Warning, Low
Warning and Low Critical thresholds.
5. Click Apply when finished.
To configure Environment settings:
1. Select a PDU to manage.
2. Click on the Settings tab.
3. Click Environment.
4. Select the sensors you want to configure and click Edit. You can configure a sensor’s Name and Unit as well as
its High Critical, High Warning, Low Warning and Low Critical thresholds.
Vertiv | Avocent® Universal Management Gateway Appliance Installer/User Guide | 91
To Next Page
Loading...
Need help?
General
