STATUS
VALUE
DESCRIPTION
on
Powering Off Target is shutting down
No Power No power is detected
Partial Power Target has sockets in both on and off states
Locked Off One or more sockets are locked in the off position
Powered Off One or more sockets are turned off
Locked On One or more sockets are locked in the on position
Idle No sessions are active
Powered On Sockets are turned on
Unknown No status available
NOTE: If a filter is applied, only those matching targets will be displayed.
7.1 Service Processors
Available service processors and their associated target devices can be viewed under the Targets tab. From the sidebar,
click on a service processor to view and/or modify its configuration settings.
7.1.1 Properties
Click the Properties tab to view general information and the FRU information for a service processor.
7.1.2 System
From the system tab you may view the power status and the status of the indicator LED (if available) on managed target
devices, manage power, turn the LED on and off remotely and view and control the time setting.
To view and control the power status:
1. Click an SP name.
2. Click the System tab. The system information window appears and displays the current power status of the
target device.
3. From the drop-down list, select the desired power action.
4. Click Apply.
To view and control the SP's indicator LED:
1. Click an SP name.
2. Click the System tab. The system information window appears and the current chassis LED status of the target
device is displayed under the Enclosure heading.
3. To change the indicator status of the target device, complete any of the following steps:
To turn the LED on and leave the LED flashing for a specified number of seconds, check the button next to
Indicator Blink then enter the number of seconds in the Seconds field.
-or-
To turn the LED on and leave the LED flashing, check the button next to Indicator On.
-or-
To turn the LED off, check the button next to Indicator Off.
4. Click Apply. The Indicator Status will reflect your changes.
Vertiv | Avocent® Universal Management Gateway Appliance Installer/User Guide | 86
To Next Page
Loading...
