Vertiv Liebert iCOM - Page 133

Time Service Settings
1. Touch , then > BMS & Teamwork > IS-Unity  Setup > Configuration > System > Time Service.
2. Adjust the settings, and touch Save.
Time Service Setting Options
External Time Source
The external source to use for time synchronization. Default is NTPServer.
Primary NTP Time Server
URL, Hostname, or IP address of the primary NTP time source. Has a 64 character maximum.
Backup NTP Time Server
URL, Hostname, or IP address of the back-up NTP time source. Has a 64 character maximum.
NTP Time Sync Rate
The rate at which time will be synchronized with the network time protocol server, if NTP is the external time source.
Time Zone
Time zone where the device is located.
Enable Auto-Sync to Managed Device
Enable automatic writing time to the managed device.
Managed Device Auto-Sync Rate
Rate at which time will be written to the managed device, if an external time source has been selected.
8 External Monitoring andBuilding ManagementSystems
125
Vertiv™ Liebert® iCOM™Installer/User Guide