Vertiv Liebert iCOM - 8.4.1 Configuring Active Networking Settings

FDM Version
The card’s FDM version; the FDM is a data model document that defines data supported by devices that use the
Velocity Protocol.
Product Sequence ID
The card’s product sequence identifier.
Device Assigned Label
Displays the label assigned to the device.
8.4.1 Configuring Active Networking Settings
Status of the currently active IP network settings for IS-Unity along with some previous values for troubleshooting IP
communication issues.
1. Touch , then > BMS & Teamwork > IS-Unity  Setup > Support > Active Networking.
2. Adjust the settings, and touch Save.
Active Networking Settings
Ethernet MAC Address
Ethernet MAC Address for the Embedded-Unity Ethernet interface.
IPv4 Address
Presently used IPv4 network address.
IPv4 Default Gateway
Presently used IPv4 network address of the gateway for network traffic destined for other networks or subnets.
Primary DNS
Presently used IPv4 Primary DNS.
Secondary DNS
Presently used IPv4 Secondary DNS.
Last DHCP/BOOTP Address
Last known IPv4 address assigned by DHCP.
Last DHCP Lease
Lease time of last known DHCP address.
8 External Monitoring andBuilding ManagementSystems
152
Vertiv™ Liebert® iCOM™Installer/User Guide