Vertiv Liebert iCOM - 8.2.8 Remote Services Configuration

Country Code
Country code (two letter abbreviation) of the organization identified as the owner of the generated certificate.
Email Address
E-mail address of the contact within the organization identified as owner of the generated certificate.
Generating a Self-Signed SSL Certificate
1. Touch , then > BMS & Teamwork > IS-Unity  Setup > Configuration > Web Server > Certificate.
2. In Generate Self-Signed SSL Certificate Mode, select the mode to use.
• If you select User Configured Settings, make entries in all of the configurable-value fields (required).
3. Touch Save.
4. Follow the instructions in the dialog to generate and install the certificate.
8.2.8 Remote Services Configuration
1. Touch , then > BMS & Teamwork > IS-Unity  Setup > Configuration > Remote Services.
2. Adjust the settings, and touch Save.
The folder contains sub-folders for connectivity and diagnostics:
• Remote Services Connectivity on the facing page
• Remote Services Diagnostics on page134
Remote Service Options and Settings
Serial Number From Device
Serial number obtained from the managed device. Identifies the device to the system unless Device Serial Number
Override is enabled.
Reset Remote Services Config
Resets configuration of the remote service back to factory defaults.
NOTE: Does not reset the communication card configuration.
Remote Service
Enables/disables remote service connection.
Device Data Sampling
Enables/disables, data sampling of the device.
Device Serial Number
Serial number used when Device Serial Number Override is enabled.
8 External Monitoring andBuilding ManagementSystems
132
Vertiv™ Liebert® iCOM™Installer/User Guide