Vertiv Liebert iCOM - 12 Customizing the Vertiv Liebert iCOM Display; 12.1 Setting General Display Properties

12 Customizing the Vertiv™ Liebert® iCOM™ Display
12.1 Setting General Display Properties
NOTE: You must be logged in to adjust the settings. See Powering On the Vertiv™ Liebert® iCOM™ and Logging
In/Unlocking Controls on page6 .
1. Touch , then > Display Options > Display Properties.
The DISPLAY PROPERTIES panel opens.
2. Touch a value to select the setting from the drop-down list
3. Touch Save to save the property settings.
• Touch Cancel to discard changes.
12.1.1 Unit Display Options
Alarm Buzzer Pattern
Selects or disables the audible alarm notification. See Enabling the Audible Alarm Notification on page92 .
Allow System On/Off
Enables/disables powering on/off the entire system of networked units from the Vertiv™ Liebert® iCOM™ display.
Backlight Brightness
Selects the brightness of the display back light.
Inactivity Timer
Time to elapse before display locks and dims.
Language
Selects the display language.
LED Brightness
Percentage brightness of the display.
Measurement System
Selects the units of measurement. Options are:
• Imperial (°F)
• Metric (°C)
12 Customizing the Vertiv™ Liebert® iCOM™ Display
175
Vertiv™ Liebert® iCOM™Installer/User Guide