Vertiv Liebert iCOM - Page 136

IPv4 and IPv6 Configuration
The IPv4 and IPv6 settings determine which internet protocol will be used for communication over the network connected to
the Ethernet port. IPv4 and IPv6 networks will run in parallel (dual stack network), but the protocols are different. See your
network administrator to determine which protocol should be enabled and to determine the correct settings.
1. Touch , then > BMS & Teamwork > IS-Unity  Setup > Configuration > Network > IPv4 or IPv6.
2. Adjust the settings, and touch Save.
IPv4 Settings
IPv4 Protocol
Enables IPv4 in the card
IP Address Method
Mode the card boots into to be a network ready device (Static, DHCP, BootP). Defaultis DHCP.
Static IP Address
Network address for the interface.
Subnet Mask
Network mask for the interface which divides a network into manageable segments
Default Gateway
IP address of the gateway for network traffic destined for other networks or subnets.
DNS Server Address Source
Source of DNS server identification (None, Automatic, Configured).
Primary DNS Server
Network address of the primary DNSserver.
Secondary DNS Server
Network address of the secondary DNS server.
IPv6 Settings
IPv6 Protocol
Enables IPv6 in the card.
IP Address Method
Mode the card boots into to be a network ready device (Static, Auto). DefaultisAuto.
8 External Monitoring andBuilding ManagementSystems
128
Vertiv™ Liebert® iCOM™Installer/User Guide