Rev AA Printing a Test Image 3-13
Videojet DataFlex 6420 Operator Manual
To perform a test print, proceed as follows:
1 If the printer is in OFFLINE state, press the Start button to put the
printer in the RUNNING state.
2 Ensure that the packaging film is placed under the printhead, if the
printer is in an intermittent application, otherwise ensure that the
packaging film is travelling past the printhead.
3 Touch the Test Print button in the Control Frame (Figure 3-13 on
page 3-12). The printer performs the test print.
4 Examine the test print to check if the image has been printed correctly.
To Next Page
Loading...