VIDEOJET DataFlex 6420 - Changing Variable Date Information

4-14 Changing Variable Information Rev AA
Videojet DataFlex 6420 Operator Manual
Changing Variable Date Information
To change the variable date information, proceed as follows:
1 Touch the required job variable to select it from the list of job
variables. The current information is shown in the data window
(Figure 4-9).
2 If the information in the data window is the information that you
want to print, go to Step 6. If you want to change the information,
perform Step 3 to Step 6.
Figure 4-9: Default Data Window