Rev AA Changing Variable Information 4-13
Videojet DataFlex 6420 Operator Manual
4 Make the necessary changes to the information, as follows:
• Touch the C/CE key to delete text. The character to the immediate
left of the cursor is deleted.
• Touch the left or right arrow keys to move the cursor to the left or
right.
• Type the new information using the keypad to add new text.
5 Touch OK when you are satisfied that the information in the data
window is correct. CLARiTY
®
checks the check box. If there are only
two variables in the job, it automatically displays the second variable.
If there are three or more variables, it displays the list of job variables,
so that you can select one.
When you touch OK at the final variable for this job (and all the check
boxes are checked) it shows you the preview of the image.
6 At the preview, perform one of the following:
• If you are satisfied with the image and you want to run the new job,
touch OK. Products will be printed with the new image until you
make further changes or select a new job.
• If you are not ready to print the job, you can leave this screen as it
is. You can touch OK at a later stage, to select the job at that time.
• If you want to step back through the job select screens to make
alterations to the variable data, touch Cancel.
• To cancel the job selection altogether, touch Home button.
To Next Page
Loading...