15User Manual Visit the ViewZ USA website at https://www.viewzusa.com
1. Setup Video and Audio Parameters
CONFIGURATION / STREAM
Step 2 Set the parameters as shown below in Table 4-1.
Procedure
Stream ID
Channel
Name
Video Encode Type
[Setting method]
Select a value from the drop-down
list box.
Select a value from the drop-down
Enter a value manually. The value
list box.
cannot exceed 32 bytes.
[Setting method]
[Setting method]
[Default value] 1
[Default value] stream1
[Default value] H.264 High Profile
[Setting method]
Select a value from the drop-down
NOTE
The H.264 High Profile codec means
high requirements on the hardware.
If the hard decoding capability is low,
use H.264 Main Profile or H.264 Base
Profile.
list box.
The device supports two streams.
• Streams 1 and 2 use the H.264 Codec
• The maximum resolution can be set for streams 1
• Only a low resolution can be set for stream 2.
ID of the video output channel.
Stream name
NOTE
NOTE
An IP camera has only one video output channel.
MJPEG is a standard intra-frame compression
No mosaic is displayed on motion images.
The stream name is combined with character,
Therefore, only the default value 1 is available.
codec. The compressed image quality is good.
MJPEG does not support proportional compression
and requires large storage space. Recording and
network transmission occupy large hard disk space
and bandwidth. MJPEG is not applicable to
continuous recording for a long period of time or
network transmission of videos. It can be used to
send alarm images.
number, character and underline.
The video codec determines the image quality and
network bandwidth required by a video. Currently,
the following codec standards are supported:
• MJPEG
SengParameter DESCRIPTION
Table 4-1 Stream configuration parameters
To Next Page
Loading...
Need help?
General
