ViewZ VZ-IP-PVM-N Series User Manual

24 User ManualVisit the ViewZ USA website at https://www.viewzusa.com
CONFIGURATION / DEVICE
2. Configuration of Device Ports
Description
Procedure
Control Port
HTTP Port
[Default value] 30001
[Default value] 80
SengParameter DESCRIPTION
Table 5-2 Device port parameters
RTSP Port
[Setting method] Enter a value manually
[Default value] 554
[Setting method] Enter a value manually
[Setting method] Enter a value manually
RTSP protocol port
Port used for audio and video transfer and
Port used in web access
signaling interaction
You must congure the HTTP port, control port, Real Time Streaming Protocol (RTSP) port and RTMP port for
device route mapping in a LAN.
Step 2 Set the parameters according to Table 5-2
Step 3 Click Apply.
• If the “This operaon will lead to the device to restart, connue?” dialog box is displayed, click Conrm.
The system automacally restarts and saves the sengs.
• If the message "Invalid Control Port, Please input an integer between 1025 and 65535" is displayed, enter
correct port numbers.
Step 1 Choose Device Conguraon > Device > Device Port.
The Device Port page is displayed, as shown in Figure 5-2.
Table 5-2 Device port parameters
Note
It’s not recommended to modify the control port. For details about the value ranges of the control port,
HTTP port, RTSP port and RTMP port, see the communicaon matrix.

ViewZ VZ-IP-PVM-N Series Specifications

General

Brand	ViewZ
Model	VZ-IP-PVM-N Series
Category	Monitor
Language	English