ViewZ VZ-IP-PVM-N Series User Manual

90 User ManualVisit the ViewZ USA website at https://www.viewzusa.com
CONFIG. / NETWORK SERVICE
3. Setup PPPoE Parameters
Preparation
Description
Procedure
Step 3 Set the parameters according to Table 9-2.
Step 2 Click the buon on to enable PPPoE.
Step 1 Choose Network Service > PPPoE.
The PPPoE page is displayed, as shown in Figure 9-3.
Figure 9-3 PPPoE page
Obtain the PPPoE user name and password from the network carrier.
If a PPPoE connecon is used, you need to enter the user name and password on the PPPoE page. Aer you
restart the device, the PPPoE sengs take eect and the device obtains a public IP address.

ViewZ VZ-IP-PVM-N Series Specifications

General

Brand	ViewZ
Model	VZ-IP-PVM-N Series
Category	Monitor
Language	English