48 User ManualVisit the ViewZ USA website at https://www.viewzusa.com
4. Loiter
CONFIG. /INTELLIGENT ANALYSIS
Function Definition
Function Settings
Figure 6-10 Loiter Interface
Step 1 Select Conguraon > Intelligent Analysis > Loiter to access the Loiter seng interface, as shown in
Figure 6-10.
Loiter allows seng the shortest loitering me for a (single) target of specied type (such as
human or vehicle) within the deployment area in the eld of view. When the loitering me of
a (single) target within this area meets the set shortest loitering me, an alarm is generated.
Step 2 Set all parameters for the Loiter. Table 6-4 describes the specic parameters.
To Next Page
Loading...
Need help?
General
