76 User ManualVisit the ViewZ USA website at https://www.viewzusa.com
Note
• Currently, An alarm is generated only when more than 75% area of a video is obscured.
• When the ambient is dark and the gray average is less than 40, an alarm of Signal Bad is generated.
11. Single Bad
CONFIG. /INTELLIGENT ANALYSIS
Function Definition
Function Settings
Figure 6-31 Single Bad Interface
Step 1 Select Conguraon > Intelligent Analysis > Single Bad to access the Single Bad seng interface, as
shown in Figure 6-31.
Signal bad refers to that an alarm is generated if an event such as tampered or shied occurs .
Step 2 Set all parameters for the Loiter. Table 6-11 describes the specic parameters.
To Next Page
Loading...
Need help?
General
