66 User ManualVisit the ViewZ USA website at https://www.viewzusa.com
8. Abnormal Speed
CONFIG. /INTELLIGENT ANALYSIS
Settings
Output Channel
SMTP
Upload Target Info
Click to enable Upload Target Info.
Click the parameter and input an ID.
[How to set]
[How to set]
[Default Value] OFF
[Default Value] OFF
is connected to an external alarm indicator, the alarm
indicator signals when an alarm is triggered.
If you check to set the Output Channel and the device
If you turn on, system will send a notice email.
Enable the function of uploading target information by
You can set the email on Network Service / SMTP.
clicking below the Live video in a flash browser
to turn into . When an alarm is triggered, the
target movement trace can be displayed (The trace
can be seen only within the deployment area and
disappears after the target leaves the deployment
area)
SengParameter DESCRIPTION
Table 6-8 Abnormal Speed Parameter Description
Deployment Time Settings
Seng deployment me: Click to select any me point within 0:00-24:00 from Monday to Sunday; or hold
down the le mouse buon, drag and release the mouse to select the deployment me within 0:00-24:00
from Monday to Sunday, and then click Apply to successfully set the me. Note: When you select me by
dragging the cursor, the cursor cannot be moved out of the me area. Otherwise, no me can be selected.
Deleng deployment me: Select the week on the le of set me which becomes red aer selecon, as
shown in Figure 6-23, and then click Delete to erase the deployment me. You can also delete selected
deployment me by means of inverse selecon.
Figure 6-23 Deployment Time Setting Interface
To Next Page
Loading...
Need help?
General
