ViewZ VZ-IP-PVM-N Series User Manual

99User Manual Visit the ViewZ USA website at https://www.viewzusa.com
7. Setup IP Filter Parameters
CONFIG. / NETWORK SERVICE
Procedure
Step 4 Click Apply.
• The message "Apply success!" is displayed. Click Conrm. The system saves the sengs.
• If other informaon is displayed, set the parameters correctly.
Table 9-6 IP Filter parameters
IP Filter
Rule Type
Black List
White List
Click the button ON.
the drop-down list box.
1. Click to enter the add black/
3. Enter End IP Address
1. Click to enter the add black/
3. Enter End IP Address
[Setting method]
[Default Value] OFF
[Setting method] Select a value from
[Setting method]
2. Enter Begin IP Address
4. Enter Descrtption
[Setting method]
2. Enter Begin IP Address
Indicates whether to enable the IP Filter.
IP filter type, includes black list and white list.
Specified network segment to allow access
Specified network segment to prohibit access
SengParameter DESCRIPTION
[Default Value] Black List
white list page, as shown in Fig. 7-8
5. Click OK, the black list added
5. Click OK, the black list added
successfully.
successfully.
white list page, as shown in Fig. 7-8
4. Enter Descrtption

ViewZ VZ-IP-PVM-N Series Specifications

General

Brand	ViewZ
Model	VZ-IP-PVM-N Series
Category	Monitor
Language	English