Event-ID Description
0xE004 Multiple parametrization of a periphery address
ZInfo1: Periphery address
ZInfo2: Slot
0xE005 Internal error - Please contact the VIPA Hotline!
0xE006 Internal error - Please contact the VIPA Hotline!
0xE007 Configured in-/output bytes do not fit into periphery area
0xE008 Internal error - Please contact the VIPA Hotline!
0xE009 Error on accessing the standard backplane bus
0xE010 There is a undefined module at the backplane bus
ZInfo2: Slot
ZInfo3: Type ID
0xE011 Master project engineering at slave CPU not possible or wrong slave
configuration
0xE012 Error at parametrization
0xE013 Error at shift register access to standard bus digital modules
0xE014 Error at Check_Sys
0xE015 Error at access to the master
ZInfo2: Slot of the master (32=page frame master)
0xE016 Maximum block size at master transfer exceeded
ZInfo1: Periphery address
ZInfo2: Slot
0xE017 Error at access to integrated slave
0xE018 Error at mapping of the master periphery
0xE019 Error at standard back plane bus system recognition
0xE01A Error at recognition of the operating mode (8 / 9 bit)
0xE01B Error - Maximum number of plug-in modules exceeded
0xE020 Error - Interrupt information is not defined
0xE030 Error of the standard bus
0xE033 Internal error - Please contact the VIPA Hotline!
0xE0B0 SPEED7 is not stoppable
(Probably undefined BCD value at timer)
0xE0C0 Not enough space in work memory for storing code block (block size
exceeded)
0xE0CB Error at SSL access
ZInfo1: 4=SSL wrong, 5=SubSSL wrong, 6=Index wrong
ZInfo2: SSL-ID
ZInfo3: Index
VIPA System 300SDeployment CPU 313-6CF13
VIPA specific diagnostic entries
HB140 | CPU-SC | 313-6CF13 | GB | 15-50 80
To Next Page
Loading...