WABECO D6000 - Page 4

4
Contents
4.3.5 Dimensions of D6000-C hs with 2.0 kW motor with trapezoidal-threaded spindle 27
Side view
4.3.6 Dimensions of D6000-C with 1.4 kW motor with ball screw spindle 28
Front view
4.3.7 Dimensions of D6000-C with 1.4 kW motor with ball screw spindle 28
Side view
4.3.8 Dimensions of D6000-C hs with 2.0 kW motor with ball screw spindle 29
Front view
4.3.9 Dimensions of D6000-C hs with 2.0 kW motor with ball screw spindle 29
Side view
4.4 Noise emission declaration for CC-D6000 – CC-D6000 hs 30
4.4.1 Technical data for CC-D6000 – CC-D6000 hs 31
4.4.2 Dimensions of CC-D6000 with 1.4 kW motor with trapezoidal-threaded spindle 32
Front view
4.4.3 Dimensions of CC-D6000 with 1.4 kW motor with trapezoidal-threaded spindle 32
Side view
4.4.4 Dimensions of CC-D6000 hs with 2.0 kW motor with 33
trapezoidal-threaded spindle Front view
4.4.5 Dimensions of CC-D6000 hs with 2.0 kW motor with 33
trapezoidal-threaded spindle Side view
4.4.6 Dimensions of CC-D6000 with 1.4 kW motor with ball screw spindle 34
Front view
4.4.7 Dimensions of CC-D6000 with 1.4 kW motor with ball screw spindle 34
Side view
4.4.8 Dimensions of CC-D6000 hs with 2.0 kW motor with ball screw spindle 35
Front view
4.4.9 Dimensions of CC-D6000 hs with 2.0 kW motor with ball screw spindle 35
Side view
4.5 Revolution selection 36
4.6 Diagram for reading off the revolutions 36
4.7 Revolution changer for 1.4 kW motor 37
4.8 Revolution changer for 2.0 kW motor 38
4.9 Electrical equipment 1.4 kW motor 39
4.10 Electrical equipment 2.0 kW motor 39
5. Achieving optimum results 40
and avoiding incorrect usage
6. Thread cutting and automatic feed 42
6.1 Thread cutting 42
6.2 Tumbler gear drive 43
6.3 Use of change gears 44
7. Maintenance 46
8. Lubrication of the machine 47
9. Readjusting the main spindle 48
10. Overload coupling 48