Maintenance
Chassis/safety devices
BA RC50_RC70 en 00
129
Checking the seat contact switch when the machine is stationary
Start the diesel engine.
Engage the working gear [1].
Stand up from the driver's seat (looking forwards). Be sure of your
footing and hold on tight.
Push the drive lever [2] out of position P to the left and into position 0.
Briefly push the drive lever [2] forwards.
a
The machine does not start moving: The seat contact switch is
working properly.
a
The machine starts moving: The seat contact switch is not working
properly.
NOTE
If the seat contact switch does not work, it must be tested and
repaired without delay. The machine must not be operated
until this work has been carried out. Request assistance from
customer service!
4.01.05 Checking the EMERGENCY STOP function
Checking function with machine at standstill (daily)
Start the diesel engine.
Parking brake active: The drive lever [2] is latched into the P position.
Press EMERGENCY STOP [1] when engine at standstill.
The machine:
a
Switches off the working functions.
a
Shuts down the diesel engine.
Checking function during machine operation (annually)
Carry out functional tests with the diesel engine running and the work
functions (e.g. vibration) switched on.
Press EMERGENCY STOP [1] with low speed 0.5 km/h (0.3 mph).
The machine:
a
Stops immediately.
a
Switches off the working functions.
a
Shuts down the diesel engine.
To Next Page
Loading...
Need help?
General
