Maintenance
Control stand
BA RC50_RC70 en 00
133
Pull the filter unit [2] out of the ventilation housing [3].
Replace the dust filter [4].
Slide the filter unit [2] into the ventilation housing [3].
Screw in and tighten the screws [1].
4.02.04 Checking the fill level of the windscreen washer fluid
The tank [1] for the windscreen washer fluid is located behind the driver's
cab.
Pure water can be used to wash the windscreen. However, we
recommend adding a standard windscreen washer agent (algae growth).
Add an antifreeze solution when outdoor temperatures are below the
freezing point of water. Make sure you use the mixing ratio specified by
the manufacturer.
Top up windscreen washer fluid in good time.
Open the cover [2] and top up the reservoir [1] with windscreen
washer fluid.
Close the tank by replacing the lid [2].
To Next Page
Loading...
Need help?
General
