Maintenance
Dynamic compaction system
BA RC50_RC70 en 00
159
Allow machine to cool down to a temperature under 30 °C (86 °F).
Correct oil level: centre of sight glass [2].
If the oil level is insufficient, fill in oil through the filler bore [3].
4.08.03 Changing the vibrator oil
% Only lubricants with this symbol are permitted ("Technical data",
page 160 onwards).
NOTE
Replace the oil on the right and left side of the drum.
Drive the machine slowly until the mark [1] is exactly perpendicular
below the axle.
Switch off diesel engine and remove ignition key.
Allow machine to cool down less than 30 °C (86 °F).
Remove filling screw [4] for pressure equalization purposes.
Screw out oil drain screw [3] and let the used oil drain into a provided
receptacle.
Screw in and tighten the oil drain screw [3] with gasket ring.
Fill in the specified oil type through the filler bore [4].
Correct oil level: centre of sight glass [2].
Screw in and tighten the filling screw [4] with gasket ring.
To Next Page
Loading...
Need help?
General
