Maintenance
Dynamic compaction system
158
BA RC50_RC70 en 00
4.08 Dynamic compaction system
NOTE
Prior to maintenance works clean roller drums thoroughly.
4.08.01 Checking the damping elements
Switch off diesel engine and remove ignition key.
Check the damping elements [1] of the roller drum suspension for
cracks.
Let replace damaged damping elements by new ones. Contact the
customer service.
4.08.02 Checking the vibrator oil fill level
% Only lubricants with this symbol are permitted ("Technical data",
page 160 onwards).
NOTE
The check must be performed on the right and left side of the
drum.
Drive the machine slowly until the mark [1] is exactly perpendicular
below the axle.
Switch off diesel engine and remove ignition key.