Maintenance
Drive unit/diesel engine
136
BA RC50_RC70 en 00
The engine oil change may only be performed by trained, skilled
personnel with suitable workshop equipment.
Before each engine oil change, a service park regeneration must be
successfully performed with the SERDIA service tool.
Then allow machine to cool down less than 30 °C (86 °F). Do not
change the engine oil until this has been done.
The entries for the number and total duration of park regenerations
is reset in the memory of the engine control unit with the SERDIA
service tool.
4.03.03 Maintenance points on the diesel engine when changing oil
NOTE
For engine maintenance, see the operating manual for the
diesel engine.
# Only lubricants with this symbol are permitted ("Technical data",
page 160 onwards).
[1] Engine oil dipstick [2] Filling opening for engine oil
[3] Drain outlet for engine oil
4.03.04 Replacing filter cartridge for the fuel filter
Switch off diesel engine and remove ignition key.
Allow machine to cool down to below 30 °C (86 °F).
To Next Page
Loading...
Need help?
General
